Cobalt-digital COMPASS 9086 Embedded Audio Loudness Processor Uživatelský manuál Strana 26

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 78
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 25
2 Installing a Rear I/O Module
2-4 9086-SD PRODUCT MANUAL 9086-OM (V4.3)
Figure 2-1 Rear I/O Module Installation
9086 Rear I/O Modules
Table 2-1 shows and describes the full assortment of Rear I/O Modules
specifically for use with the 9086.
Note: Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied with
removable screw terminal block adapters. For clarity, the adapters are omit-
ted in the drawings below.
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
Note: Rear I/O Modules RM-9086-C and -H occupy two rear
module slot mounting locations and use two captive screws.
Rear I/O Module RM-9086-G occupies three rear module
slot mounting locations and uses three captive screws.
1
2
Zobrazit stránku 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 77 78

Komentáře k této Příručce

Žádné komentáře